goglunique.blogg.se - How to install oil catch can on 7.3 powerstroke

#How to install oil catch can on 7.3 powerstroke install#
#How to install oil catch can on 7.3 powerstroke archive#

#How to install oil catch can on 7.3 powerstroke install#

Install the Truck Edition Module on Your 6.6L GM Duramax Engine.

#How to install oil catch can on 7.3 powerstroke archive#

← Previous Post Next Post → Related Posts and Blog Archive Related Posts Let's keep that Powerstroke diesel engine running right! Good luck. A typical catch can plugs into a hose running from the top of your engine's crankcase to the intake manifold. That damage may be difficult to detect, as injectors can still run for a short period after damage occurs. Here's how they work, and why you might want to install one on your own car. Failure to properly prime the fuel system after installing new filters can damage the fuel injectors. WARNING: Complete step 7 before starting the vehicle.

To prime the fuel system and bleed out any air, turn the ignition to the Run position three separate times-for 30 seconds each time.

Reinstall the blacktop cap, using the 24mm socket or ½" square drive ratchet to torque the bolt to 124lb.

Insert the new secondary filter into the housing.

NOTE: Again, remember to properly dispose of the fuel.

Using the turkey baster, drain the excess fuel from the housing.

Remove the fuel filter from the housing and the o-ring from the lid.

Using the 24mm socket or ½" square drive ratchet, remove the blacktop cap-on the right.

To replace the secondary fuel filter, follow these seven steps: Secondary Fuel Filter Replacement Instructions

Being mindful not to over tighten or cross thread it, reinstall the allen plug-the brass plug removed during step 2 above.

Insert the new filter and cap section into the fuel pump, using the 36 mm socket to tighten the cap securely to 19lb.

Install the supplied o-ring into position on the end cap.

Note: Once seated properly in the cap, the new filter will snap into place.

Install the new primary fuel filter into the cap.

NOTE: After draining the filter for a full 24 hours, you can place it in a lidded coffee can or leak-proof plastic bag to safely take it to a recycling center that accepts scrap metal.

Pull the old filter and the o-ring from the cap, properly disposing of both.

NOTE: The fuel filter will slide out along with the cap. Using the 36mm socket, remove the large black end cap-on the engine-side end of the pump.With the catch bucket directly in place, drain the fuel/water completely. Using the 6mm allen wrench, remove the allen plug.ī. On the side of the fuel pump, locate the allen plug-the small, brass plug.Ī.Place the tub or bucket beneath the fuel pump-under the driver’s door on the frame rail.To replace the primary fuel filter, carefully follow this 8-step process: Primary Fuel Filter Replacement Instructions Coffee Can or Other Leak-Proof Container-for the old filter fuels.NOTE: We prefer either Motorcraft fuel filters or Racor replacement fuel filters. To help you out, Area Diesel Service put together some clear instructions below. Changing the fuel filters on ’03 - ’07 Ford 6.0L Powerstroke engines is within your capabilities.